TorkLift StableLoad Ford/Dodge (Upper Overload)

Torklift's Stableload for upper overload applications is designed to replace the smaller, inefficient factory overload bump stop pads, putting the upper overload springs to work sooner dramatically stabilizing the vehicles suspension and making the vehicle's passengers and load significantly safer. The Stableload upper overload is available for a very quick and simple no drill installation with serious improvement results. This is accomplished by bolting each of the StableLoads (four per kit) onto each overload frame bump stop pad (front and rear passenger side, front and rear driver side) Stableload kits work equally well with or without aftermarket airbags overloads. Each precision crafted Stableload kit carries our legendary lifetime warranty and is proudly made in the USA.

The A7200 is a NO DRILL APPLICATION and must have factory installed upper overload.
-Will not work in conjunction with Supersprings
-Due to factory overload engagement design, some applications have progressive engagement, where rear springs will contact first.
-Drilling of rubber pad on some older Dodge applications may be required. Depending on the vehicle model, suspension package and condition, actual distance between the StableLoad and vehicle frame overload contact bracket may vary. In some rare instances, when the vehicle is not carrying a load the StableLoad may come into contact on occasion due to rough road conditions and other anomalies.